ملخص
Abstract
Water contamination is one of the major problems which the world is facing today. Water contamination not only effect environment and human health, but it has also impacts on economic and social costs. There are various ways used commercially and non- commercially to fight this problem which is advancing day by day due to technological progress There are many methods used for wastewater treatment, among these methods, the use of biological filters " trickling filter ", which depends on The basic idea is to get a larger surface area to get a better handle on the percentage. A composite media is used to replace the conventional stone in order to improve wastewater treatment in this thesis. The aim of this thesis to improve the performance of biological filters using nanotechnology, where to enhancing polymer media in biological and reinforced polypropylene by carbon fiber filters and talc by using electro spinning technology to produce the reinforced fiber that outlet from extruder. Design and simulate the extruder / die characteristics and studying The drag flow and pressure flow were then extracted from the screw parameters which lead into the calculation of the operation point and the operating pressure for the die. Also studying the effect of pressure and viscosity. Calculation of , and extruder characteristic is performed in order to allocate the operating point of the extruder.Two brand of carbon fiber are used in this thesis. The chapter type is at A tensile strength of 800 MN/m2. is selected. The operating pressure of the extruder is found to vary form 29.8 to 38.95 MN/m2 at an operating flow rate of 1.52*10-5 m3/sec. depending on the percentage of carbon fiber used in the blend.